Pelco DX3000 - page 27

26 Pelco Manual C681M-D (2/02)

6. Do one of the following:

•Turn the JOG dial to go to another item in this menu.

•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-

other menu.

•Press the SET UP button to exit the programming mode.

M-DET SETTING

Refer to

Motion Detection

for instructions.

ARCHIVE POINTER RESET

The recorder places the Archive Pointer where the archive stops. For example, 100 hours of

data recorded on the unit’s hard disk is to be transferred to a medium with only 80 hours of

available recording space. When the backup process is completed, the Archive Pointer will

memorize the hard disk’s 80-hour mark. When the next backup process is initiated, backup

will begin at this point.

If you want to reset the Archive Pointer, follow the steps below.

Skip steps 1 and 2 if they have already been done.

1. Press the SET UP button to display the Menu Setting menu.

2. Move the cursor next to SERVICE, and then turn the SHUTTLE ring to the right.

The Service menu appears.

3. Turn the JOG dial until the cursor is next to ARCHIVE POINT RESET, and then turn

the SHUTTLE ring to the right. The option starts flashing.

4. Turn the JOG dial to select ON.

5. The message “TURN THE SHUTTLE RING >> to EXECUTE.” appears on the screen.

Turn the SHUTTLE ring to the right to reset the archive pointer. The pointer resets and

the option returns to OFF.

6. Do one of the following:

•Turn the JOG dial to go to another item in this menu.

•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-

other menu.

•Press the SET UP button to exit the programming mode.