IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclo-
sure, it is designed for indoor use only and it must not be installed where exposed to rain
and moisture.
3. The camera and lens combination shall not exceed 10 pounds (4.5 kg).
4. Only use replacement parts recommended by Pelco.
5. The installation method and materials should be capable to supporting four times the
weight of the enclosure, pan/tilt, camera and lens combination.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.

DESCRIPTION

The ED1000 low-profile ceiling enclosure for 2/3-inch format cameras is designed to accom-
modate two cameras mounted side-by-side to provide viewing in opposite directions, thus
eliminating the need for two separate enclosures. Two independent camera mounting tables
are provided for camera positioning. Some adjustments in table height and angle will be re-
quired to obtain the desired viewing position. Engineered to be mounted in fixed or dropped
ceilings, the upper section mounted above the ceiling is constructed of aluminum to meet most
fire code requirements for installation in open plenum ceilings.
The ED1000 is engineered for ease of installation and service. The lower section is hinged to
provide convenient access for adjusting camera and lens. The upper section has generous
interior dimensions which allow additional camera angle adjustments to be made.
The ED1000 is equipped with a tamper-resistant lock for security protection. Cable entry is
through conduit knockouts.

INSTALLATION

To mount the ED1000 directly into a fixed or dropped ceiling, perform the following steps:
1. Determine the location and direction of the enclosure to be mounted. Ideally the enclo-
sure cutout should be parallel and adjacent, or perpendicular, to any ceiling structure.
Avoid cutting into any ceiling structural members.
2. Open the cover of the enclosure to expose the mounting holes in the flange.
3. Remove any appropriate knockouts.
4. Insert the enclosure into the opening and secure with the appropriate fasteners.
C403M-B (12/99)ED1000Ceiling Enclosure
This symbol indicates that danger-
ous voltage constituting a risk of
electric shock is present within
this unit.
This symbol indicates that there
are important operating and main-
tenance instructions in the litera-
ture accompanying this unit.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
300 W. Pontiac Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
www.pelco.com