Pelco EM1109, EM2000, EM2200 specifications

C207M-D (7/03)

EM1109/EM2000/EM2200

Enclosure Mounts

®

IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.

1. Installation and servicing should be done only by qualified service personnel and conform

to all local codes.

2. Installation shall be done in accordance with all local and national electrical and mechanical

codes utilizing only approved materials.

3. Use only installation methods and materials capable of supporting four times the maximum

specified load.

4. Use stainless steel hardware to fasten the mount to outdoor surfaces.

Please thoroughly familiarize yourself with the information in this manual prior to installation

and operation.

DESCRIPTION

The EM1109/EM2000/EM2200 enclosure mounts have been engineered for use with all enclo-

sures with a 2-inch (5.08 cm) mounting hole pattern and can be installed on a horizontal or

vertical pipe or pole that has a minimum 3-inch (7.62 cm) diameter.

These enclosure mounts feature fully adjustable swivel heads, allowing 360-degree horizontal

movement and cable feedthrough to conceal wiring.

EM1109 Medium duty pedestal mount for horizontal pipe or pole mounting; will work on vertical

pipe/pole mounting; manually adjustable swivel head; 8.91 inches (22.63 cm) long

EM2000 Medium duty 90-degree J-mount for vertical pipe/pole mounting; manually adjust-

able swivel head; 14.75 inches (37.46 cm) long

EM2200 Medium duty “hook” mount for horizontal pipe/pole mounting; manually adjustable

swivel head; 18.7 inches (47.5 cm) long

INSTALLATION

The EM1109/EM2000/EM2200 enclosure mounts include two 1/4-20 x .625 hex head bolts to

mount the enclosure and three stainless steel straps for attaching the mount to the pole or pipe.

To install the mount, follow the steps below.

1. Inser t the stainless steel straps through the slots in the mount bracket. Position and

secure the mount on the pole or pipe by tightening the strap clamps.

2. Attach the enclosure or camera securely with the two 1/4-20 bolts provided.

3. Loosen the bolts on the swivel head and adjust for pan rotation (360 degrees) and tilt

angle (75 degrees up or down). Tighten bolts and lock into place.

SPECIFICATIONS

Pan Adjustment: Unlimited 360°

Tilt Adjustment: ±75°

Construction: Aluminum

Finish: White epoxy powder coat

Locking Method: 3/8-16 hex head bolts

Enclosure Mounting: Two 1/4-20 mounting bolts (supplied)

Suggested

Mounting Method: Slots are provided to allow the use of straps for mounting to pole or pipe.

Three stainless steel straps are supplied. Strap length 28.5 inches (72.39 cm).

Maximum Load: 40 lb (18 kg)

(Design and product specifications subject to change without notice.)

CAUTION:

Make

certain the pole or pipe

is capable of support-

ing the full load of the mount,

enclosure, and camera.

3050 Pelco Way

Clovis, CA 93612-5699

USA

In North America & Canada:

Tel (800) 289-9100

FAX (800) 289-9150

International Customers:

Tel (1-559) 292-1981

FAX (1-559) 348-1120