Pelco HSWM12 service manual

The HSWM12 Wall Mount is designed for use with the HS4012 High-Security Enclosure. The

mount features tamper-resistant hardware and manually adjustable pan/tilt positioning. The

wall mount is fabricated from 10-gauge steel and will support loads up to 40 pounds (18 kg).

To install the HSWM12 mount, perform the following steps (refer to Figure 1):

1. Determine the mounting location. The mounting surface should be able to support four

times the combined weight of the mount, enclosure, and camera.

2. Use the flanged end of the HSWM12 as a template and mark the four fastener hole posi-

tions on the mounting surface. Set the HSWM12 mount to the side and prepare the holes

for the fasteners.

3. Position the HSWM12 mount over the mounting holes. Secure with a minimum of four

3/8-inch fasteners (not supplied). If you install the HSWM12 outdoors, seal the fastener

holes with an appropriate sealant to prevent water damage. Apply the sealant between

the mount and the mounting surface.

4. Attach the enclosure or camera with the two 1/4-20 tamper-resistant screws (supplied).

5. Loosen the tamper-resistant bolts on the top and lower brackets. Adjust the pan and tilt to

the desired settings. Tighten bolts and lock into place.

If you need parts for your unit, obtain a service manual in one of the following ways:

•Go to Pelco’s web site at ftp://www.pelco.com and find service manual C259SM.

•Contact Pelco’s Literature Department and request service manual C259SM.

C259M-A (3/00)HSWM12 High-SecurityWall Mount

300 W. Pontiac Way,

Clovis, CA 93612-5699

USA

In North America & Canada:

Tel (800) 289-9100

FAX (800) 289-9150

International Customers:

Tel +1 (559) 292-1981

FAX +1 (559) 348-1120

www.pelco.com

FASTENER HOLE

ENCLOSURE/CAMERA

MOUNTING HOLES

TOP BRACKET

LOWER

BRACKET

TAMPER-

RESISTANT

SCREWS

ARM