Pelco LL27LM, Mounting Bracket manual

Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981

FAX (800) 289-9150 or (1-559) 292-3827

International Customers call (1-559) 292-1981 or FAX (1-559) 348-1120

1.0 WARNINGS

Prior to installation and use of this product, the follow-

ing WARNINGS should be observed.

1. Installation and servicing should only be done by

Qualified Service Personnel and conform to all

Local codes.

2. Use only installation methods and materials ca-

pable of supporting four times the maximum speci-

fied load.

3. Only use replacement parts recommended by Pelco.

Please thoroughly familiarize yourself with the informa-

tion in this manual prior to installation and operation.

2.0 DESCRIPTION

The LL27LM mounting bracket is designed to allow you

to mount an LL27 infrared illuminator to any Legacy®

Series enclosure. Only one infrared illuminator can be

mounted to the enclosure/pan and tilt assembly.

3.0 INSTALLATION

3.1 INSTALLING THE LL27LM

BRACKET

3.1.1 EH4700L/EH5700L Series

Enclosures

To install the LL27LM bracket perform the following

steps. (Refer to Figure 3.)

1. Remove enclosure from pan/tilt, if necessary.

2. Loosen the two 1/4-20 bolts (item K) from the tilt

table (item 3) on the bottom of the enclosure.

3. Remove cradle (item 4) and replace with LL27LM

mounting bracket.

The long arm of the LL27 bracket should be posi-

tioned over the tilt gear side of the pan/tilt unit.

4. Re-attach the tile table (item 3) using the two 1/4-

20 bolts previously removed.

LISTED