Pelco C1656M-A (2/06), NVR5000PS manual

C1656M-A (2/06)Endura

™

NVR5000PSReplacement Power Supply

This document describes how to replace a failed power supply in any of the following:

• NVR5100 Series network video recorder

• SEB5100 Series storage expansion box

• DVR5300 Series digital video recorder

NOTES:

• You can replace one failed power supply without shutting down the unit.

• No tools are required to replace this component.

• The NVR5100 rear panel is shown in this document. The power supplies are in the same locations in the SEB5100 and the DVR5300.

1. Review all instructions in this document before proceeding.

2. Identify the failed power supply. The status indicator will be red or dark.

3. Unplug the power cord from the failed power supply as follows:

a. Unplug the power cord for the failed power supply from the power source.

b. Unplug the power cord from the failed power supply at the rear panel of the unit.

4. Using your thumb, lift the power supply latch while holding the pull handle.

Figure 1.

Releasing the Power Supply Latching Mechanism

WARNING:

For safety, you must unplug the power cord from the wall socket or other power source before unplugging it from the failed power

supply on the unit.

POWER

SUPPLY

LATCH

PULL HANDLE

MODEL

FREQ

50/60HZ

Sample Text

AMPS

VOLTS

Sample Text

REV

Sample Text

03267-39-0020

MFG BY PELCO, CLOVIS, CA

Model

Audio/VideoApparatus

91KK

MADE IN USA

POWER

SUPPLY

STATUS

INDICATOR