Pelco Manual C918M (11/96) 3

Figure 1. RMA901 Dimension Drawing

3.0 INSTALLATION To mount the monitor, perform the following steps.
1. Remove rubber feet on bottom of monitor.
2. Install monitor through rear of rack and align holes in bottom of monitor with
mounting holes in rack.
3. Use hardware from rubber feet to mount monitor to rack.
4. Install rack and monitor as an assembly into console and make any required
electrical connections.
5. Hold into place, aligning mounting holes of the RMA901 with mounting holes
in console, and insert and tighten required fasteners (not supplied). If only a
single monitor is used, install cover plate up against window frame and then
insert fasteners and tighten.
4.0 SPECIFICATIONS Dimensions: See Figure 1
Construction: 16-gauge steel
Weight: 5.56 lbs (2.50 kg)
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES.
1.06
(2.69)
Ø .250 (.635) SLOT, 4X
.375
(.94)
C
L
17.35 (44.07)
19.00 (48.26)
8.94
(22.71)
10.50
(26.67) 1.44
(3.66)
.75
(1.90) .83
(2.11)
9.00
(22.86)
9.4
(24.23)
.50 (1.27)
14.80
(37.59) Ø .250 (.63) SLOT
8X
6.87
(17.45)
6.79
(17.25)
8.29
(21.06)
.80
(2.03) .58
(1.47) 1.71
(4.43) 5.50
(13.97) Ø .500 (1.27), 4X