Perreaux dealer for any voltage adjustment and updating of this label.

- FM ANTENNA SOCKET

This socket is for the connection of the FM antenna provided. The antenna should be extended and positioned for the best reception however it should be noted that superior performance will be achieved using a professionally installed outdoor antenna.

NOTE: Outdoor antenna's can be dangerous if incorrectly installed and through incorrect earthing - we recommend using the services of a registered contractor for outdoor antenna installation.

-AM / GROUND ANTENNA SOCKETS These sockets are for the connection of the AM loop antenna provided. Again this antenna should be positioned for the best reception. A mounting clip is provided on the rear panel to hold this antenna. It should be noted that the inherent performance of AM signal broadcasts is not of high fidelity and can be noisy, hence the reason for the popularity of FM broadcasts.

-LEFT / RIGHT OUTPUT SOCKETS

These are high quality gold plated RCA type sockets for the connection of the TU6 to a pre or integrated amplifiers TUNER input. When connecting the TU6 to auxiliary equipment terminate the interconnect cables with a red plug for the right channel and white, black or blue for the left channel. These are the most commonly accepted colour coding combinations in use internationally to help maintain channel and phase integrity i.e. left to left, right to right, positive to positive, and negative to negative.

An initial set of interconnects is provided however we recommend substituting higher

quality cables at your earliest convenience for improved fidelity.

- MAINS/LINE INPUT RECEPTACLE

This receptacle accepts the female end of the mains power cord. For more information regarding MAINS/LINE VOLTAGE and connection see the relevant sections.

INSTALLATION / OPERATION PROCEDURES

The Perreaux Tuner employs a quartz PLL synthesiser for easy and accurate tuning. Tuning frequency is visible on the digital display, and you can tune in to the desired station very accurately. With the units memory circuit, you can pre-set memory tuning, letting you recall a stored station frequency instantly with a single tap of a button.

One station can store one AM or one FM station in its memory; a total of 20 AM or FM stations can be stored.

The power source of the TU6's memory circuit is a capacitor back-up type. The electrical energy accumulated in the capacitor while the unit was switched ON will retain the frequencies stored in the memory circuit for a minimum of seven (7) days.

Before commencing operation, check to make sure all antenna preamplifier and power connections are properly made.

-Set the volume control on the control amplifier to a low position and selection switch to the tuner position.

-Turn on the TU6, the control amplifier and lastly the power amplifier (if applicable).

-Depress the FM or AM Band button on the remote controller to select the band required.

-Tune in to the desired station( See relevant sections TUNING and AUTO TUNING.

-Raise the volume to the desired level and enjoy listening

NOTE: If you have turned off the TU6 and turn it on again, it will tune into the station frequency to which it was tuned immediately before turn-off.

INSTALLATION AND OPERATION PRECAUTIONS

Precautions which should be observed during installation and operation are:

- Leave sufficient clearance between the top

of the TU6 and the bottom of equipment above if installed in a rack or stack.

-Always operate in a horizontal position.

-Install away from excessive heat and moisture. Do not allow the ambient temperature around the TU6 to exceed 40º Celsius (105º Fahrenheit.)

-Check the mains/line voltage stated on the rear panel of your .TU6 Supply voltage must be within +/- 5% of the stated voltage.

-Connect all your hi-fi equipment to the same mains/line source to avoid possible earthing problems.

-The protection fuses for the TU6 are internal and not user serviceable.

6