14
The Audio/Video (Monitor) Output jacks
can be used for recording a selected TV
(Antenna Input/tuner signal source) Channel.
This recording can even be completed while
viewing another external Audio/Video Source
Select option. (For example: DVD program
playback shown through the A/V 1 or 2 Input
source connection.)
NOTE: Refer to page 7 for the proper
hookup of an accessory device to the AV 1
IN(put) jacks. Follow the instructions on how
to tune to the AV 1 channel to view a DVD
program playback or pre-recorded VCR tape.
The following steps allow you to connect a
VCR to record a selected TV channel pro-
gram through the Monitor Outputs.
1Connect one end of the yellow Video
Cable to the Monitor Out VIDEO
plug. Connect the other end to the
VIDEO IN plug on the VCR.
2Connect one end of the red and white
Audio cable from the Monitor Out
AUDIO L and R plugs on the TV to the
AUDIO IN plugs on the VCR.
3Tune the TVto the program channel
you wish to record.
Note: Once selected be sure to leave
the TV channel tuned to the desired
program until the complete recording is
finished.
4Press the SOURCE SELECT button
on the remote control to display the
SOURCE menu.
5Press the CURSOR UP or DOWN
button to select the AV1 option (or any
of the other AV connection options
from which you wish towatch an
accessory device playback. Example:
DVD playback on AV 1).
6Press the OK button to confirm your
selection. The TV will change to the
AV1 channel input (or any other source
option you wish to select).
7Turn the VCR ON,insert a blank
VHS tape and it’s ready to record the
channel program you selected previ-
ously in step #3.
USING THE MONITOR OUTPUT JACKS
1
2
7
SOUND PICTURE
ACITVE
CONTROL
ZOOM
4
Source TV
AV1: VCR
AV2: Recorder
AV3: DVD
AV4: HD
SIDE: Camera
5
5
6
JACK PANEL
Located on the
back of the TV
AUDIO CABLES
(Red & White)
AV1 Sample DVD
(accessory device
Hookup from Page 7)
MONITOROUT
VIDEO &
AUDIO L(eft) and R(ight)
Recording VCR
VIDEO CABLE
(Yellow)