Philips 14PV360/07 manual Manual TV channel search Using the satellite receiver, Automatic Tuning

Manual TV channel search Using the satellite receiver

In some cases it could occur that all of the TV channels were not found and saved during the Preparation for use. In this case, the missing or coded TV channels must be searched for and stored manually.

1.Press MENU . The main menu will appear.

2.Select 'TUNER SET UP' with

K B

L C

and

confirm with

.

B 1

3.Select 'MANUAL TUNING' with

K B

L C

and confirm with

.

B 1

Select 'PROG.' with

K B

L C

4.

.

. Then press

B 1

MANUAL TUNING

→PROG. P55

CHANNEL 055

DECODER [OFF]

SKIP[OFF]

SELECT K L CHOOSE B

END=EXIT

5.With K B L C or 0..9 , select the desired programme number that you want to use for the TV channel, e.g. 'P01'. Then press B 1 .

What is a special channel?

TV channels are transmitted in certain pre-defined frequency ranges. These ranges are divided into channels.

A specific frequency/channel is assigned to each TV station.

Certain frequency ranges are specified as special channels (hyperband channels).

6.Select 'CHANNEL' with K B L C , and con-

firm with B 1 . Then enter the desired chan- nel with 0..9 .

When a channel is found,it will stop searching. If

this is the channel you want, press B 1 . If you set 'SKIP' on for a channel, this channel will be ignored when going through the channels with

P+ or P– .

To search for other TV channels, begin again at step 4.

I don't know the channels for my TV stations In

this case, press K B L C in 'CHANNEL' to start the automatic channel search. A changing channel number will appear on the TV screen. Continue the automatic search until you have found the desired TV channel.

7.To end, press STATUS/EXIT .

EN

You can receive channels from the satellite

receiver via the scart socket AV1/EXT1 .

To do this, select the channel number 'AV1' by pressing 0,0,1, with the keys 0..9 on the remote control.You will have to select the channel you want to receive on the satellite receiver itself.

Automatic Tuning

During installation, all available TV channels are searched for and saved. If you want to replace the TV channels already saved with the new ones, follow the instructions below.

1.Press MENU . The main menu will appear.

2.Select 'TUNER SET UP' with						K B		L C		and
confirm with			.
	B 1
3.Select 'AUTO	TUNING' with								and
					K B		L C
confirm with				.
		B 1

PLEASE WAIT

STARTFINISH

❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚

4.The automatic TV channel search starts. This allows the TV-Video Combi to save all avail- able TV channels. This procedure may take several minutes.

5.When the TV channel search is complete, 'AUTO TUNING COMPLETED' will briefly appear on the TV screen.

6 6