36

Access CAM services

1 Insert and activate the CAM (see ‘Insert
and activate a CAM’ on page 36).
2 Press OPTIONS.
3 Select [Common interface].
»Applications provided by the digital TV
service operator are displayed.
Note
•This menu option is available only if the CAM is
inserted and activated correctly.
Use Philips EasyLink
Get the most out of your HDMI-Consumer
Electronic Control (CEC) compliant devices
with Philips EasyLink enhanced control features.
If your HDMI-CEC compliant devices are
connected through HDMI, you can control
them at the same time with your TV remote
control.
To enable Philips EasyLink, you need to:
• Connect at least two HDMI-CEC
compliant devices through HDMI
• Congure each HDMI-CEC compliant
device properly
• Switch on EasyLink
Note
•The EasyLink-compliant device must be switched on
and selected as the source.
•Philips does not guarantee 100% interoperability with
all HDMI CEC devices.
Use a Conditional Access Module
A Conditional Access Module (CAM) is
provided by digital TV service operators to
decode digital TV channels.
Note
•Refer to the documentation from your service
operator on how to insert a smart card into the
Conditional Access Module.

Insert and activate a CAM

Caution
•Be sure to follow the instructions described below.
Wrong insertion of a CAM may damage both the
CAM and your TV.
1 Switch off the TV and disconnect it from
the power outlet.
2 Following the directions printed on the
CAM, gently insert the CAM into the
COMMON INTERFACE at the side of the
TV.
3 Push the CAM in as far as it will go.
4 Reconnect the TV to the power outlet.
5 Turn on the TV and wait for the CAM to
be activated. This may take several minutes.
Do not remove the CAM from the slot
when in use — this action deactivates
digital services.
EN
Downloaded From TV-Manual.com Manuals