—Whendelays occur for low sounds due
tothe influence of the LPF on active
subwoofersor external amps.
!AutoTA and EQ changes the audio settings
asbelow:
—Thefader/balance settings return to the
centerposition. (Refer to page 85.)
—Theequalizer curve switches to Flat.
(Referto page 90.)
—Itwill be adjusted automatically to high
passfilter setting for front,center and
rearspeaker.
!Ifyou carr y out auto TAand EQ when a pre-
vioussetting of this already exists, the set-
tingwill be replaced.
Carryingout auto TA and EQ
1 Stopthe car in a place that is as quiet
aspossible, close all doors, windows and
thesun roof, and then turn the engine off.
Ifthe engine is left running, engine noise may
preventcorrect auto TA and EQ.
2 Fixthe supplied microphone in the cen-
terof the headrest of the driver’s seat, fa-
cingforward, using the belt (sold
separately).
Theauto TA and EQ may differ depending on
whereyou place the microphone. If desired,
placethe microphone on the front passenger
seatto carry out auto TA and EQ.
3 Turnthe ignition switch to ON or ACC.
Ifthe car ’s air conditioner or heater is turned
on,turn it off. Noise from the fan in the air
conditioneror heater may prevent correct auto
TAand EQ.
#PressSRC/OFF to turn the source on if this
unitis turned off.
4 Selectthe position for the seat on
whichthe microphone is placed.
Referto Using the position selector on page
84.
#Ifno position is selected before you start auto
TAand EQ, Front-L is selected automatically.
5 Touchthe source icon and then touch
Offto turn this unit off.
6 Touchthe screen to display the touch
panelkeys.
7 TouchAV Menu and then touch
InitialMenu to display the function names.
8 TouchAuto EQ&TA to enter the auto TA
andEQ measurement mode.
9 Plugthe microphone into the micro-
phoneinput jack on the multi-channel pro-
cessor.
Fordetails concerning operation, refer to the
multi-channelprocessor ’s operation manual.
10 TouchStart to start the auto TA and EQ.
Available accessories
En 93
Section
19
Availableaccessories