Connection
When connecting with optional
USB/iPod input
This product
RGB input
iPod with video capabilities (sold separately)
Dock connector 
|
|
|
| Section |
| Installation |
|
| 25 |
|
|
|
| 26 |
|
|
|
| |
Notes | Installation using the screw |
| ||
! Check all connections and systems before | holes on the side of the unit | English | ||
| final installation. | |||
|
|
| ||
|
|
|
| |
! Do not use unauthorized parts as this may | % Fastening the unit to the factory radio- |
| ||
| cause malfunctions. | mounting bracket. |
| |
! Consult your dealer if installation requires | Position the unit so that its screw holes are |
| ||
| drilling of holes or other modifications to the | aligned with the screw holes of the bracket, and |
| |
| vehicle. | tighten the screws at 3 locations on each side. |
| |
!Do not install this unit where:
—it may interfere with operation of the vehicle.
—it may cause injury to a passenger as a result
of a sudden stop.
!The semiconductor laser will be damaged if it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the unit is installed at an angle of less than 30°.
1.5 m (4 ft. 11 in.)
USB cable
(Supplied with this unit) Connect to separately sold USB device.
Interface cable
!When installing, to ensure proper heat dis- persal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not block- ing the vents.
Leave ample
space | 5 cm |
| 5 cm 5cm |
!To some types of vehicles, this unit cannot be properly installed. In such case, use the op- tional installation kit
21
3
4
1If the pawl gets in the way, bend it down.
2Factory radio mounting bracket
3Use either truss (5 mm × 8 mm) or flush sur- face (5 mm × 9 mm) screws, depending on the bracket screw holes.
4Dashboard or console
En 49