Operating this unit
Operating this unit
Section
02
Loudness compensates for deficiencies in the low- and
1Press M.C. to display the setting mode.
2Turn M.C. to select the desired setting. OFF
3Press M.C. to confirm the selection.
SUBWOOFER1 (subwoofer on/off setting)
This unit is equipped with a subwoofer output which can be turned on or off.
1Press M.C. to display the setting mode.
2Turn M.C. to select the desired setting. NORMAL (normal
3Press M.C. to confirm the selection.
SUBWOOFER2 (subwoofer adjustment)
The
Only frequencies lower than those in the selected range are outputted from the subwoofer.
1Press M.C. to display the setting mode.
2Press M.C. to cycle between the
3Turn M.C. to select the desired setting.
Output level:
SLA (source level adjustment)
SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sour- ces.
!Settings are based on the FM volume level, which remains unchanged.
!The AM volume level can also be adjusted with this function.
!When selecting FM as the source, you cannot switch to SLA.
1Press M.C. to display the setting mode.
2Turn M.C. to adjust the source volume. Adjustment range: +4 to
3Press M.C. to confirm the selection.
Initial Settings
1Press and hold S (SRC/OFF) until the unit turns off.
2Press M.C. and hold until function name appears in the display.
3Turn M.C. to select the initial setting. After selecting, perform the following proce- dures to set the initial setting.
CLOCK SET (setting the clock)
1Press M.C. to display the setting mode.
2Press M.C. to select the segment of the clock display you wish to set.
3Turn M.C. to adjust the clock.
AUX (auxiliary input)
Activate this setting when using an auxiliary device connected to this unit.
1Press M.C. to turn AUX on or off.
USB (plug and play)
This setting allows you to switch your source to USB/iPod automatically.
1Press M.C. to turn the plug and play function on or off.
ON – When a USB storage device/iPod is con- nected, depending on the type of device, the source is automatically switched to USB/iPod when you turn on the engine. If you disconnect your USB storage device/iPod, this unit’s source is turned off.
OFF – When a USB storage device/iPod is con- nected, the source is not switched to USB/ iPod automatically. Please change the source to USB/iPod manually.
SW CONTROL (rear output and subwoofer set- ting)
The rear speaker leads output and RCA output can be used for
If you switch to
Initially,
1Press M.C. to display the setting mode.
2Turn M.C. to change the output and press to select.
3Turn M.C. to change the setting.
!Even if you change this setting, there will be no output unless you turn the sub- woofer output on (refer to SUBWOOFER1 (subwoofer on/off setting) on this page).
!If you change this setting, subwoofer out- put in the audio menu will return to the fac- tory settings.
DEMO (demo display setting)
1Press M.C. to turn the demo display on or off.
SCROLL (scroll mode setting)
When ever scroll is set to ON, recorded text information scrolls continuously in the display. Set to OFF if you prefer the information to scroll just once.
1Press M.C. to turn the ever scroll on or off.
Using an AUX source
1Insert the stereo mini plug into the AUX input jack.
2Press S (SRC/OFF) to select AUX as the source.
Note
AUX cannot be selected unless the auxiliary setting is turned on. For more details, refer to AUX (auxiliary input) on this page.
Turning the clock display on or off
%Press
to turn the clock display on or
off.
# The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds.
English
En
9