Installation | Installation |
Section
03
!When installing, to ensure proper heat dis- persal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not block- ing the vents.
Leave ample
space | 5 cm |
5 cm
5cm
DIN front/rear mount
This unit can be properly installed using either
Use commercially available parts when instal- ling.
DIN
1 Insert the mounting sleeve into the dash- board.
For installation in shallow spaces, use the supplied mounting sleeve. If there is enough space, use the mounting sleeve that came with the ve- hicle.
2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place.
1
2
1Dashboard
2Mounting sleeve
#Make sure that the unit is installed securely in place. An unstable installation may cause skipping or other malfunctions.
DIN
1Determine the appropriate position where the holes on the bracket and the side of the unit match.
2 Tighten two screws on each side.
1 | 3 |
|
2
1Screw
2Mounting bracket
3Dashboard or console
!Use either truss (5 mm × 8 mm) or flush sur- face (5 mm × 9 mm) screws, depending on the bracket screw holes.
Removing the unit
1 Remove the trim ring.
1Trim ring
2Notched tab
!Releasing the front panel allows easier ac- cess to the trim ring.
!When reattaching the trim ring, point the side with the notched tab down.
2Insert the supplied extraction keys into both sides of the unit until they click into place.
3Pull the unit out of the dashboard.
Removing and
You can remove the front panel to protect your unit from theft.
For details, refer to Removing the front panel and
Securing the front panel
The front panel can be secured with the supplied screw.
1
1Screw
English
En 15