The Initial Setup menu
13
92
En

Chapter 13

The Initial Setup menu

Using the Initial Setup menu

The Initial Setup menu is where you can set various recorder options for sound, picture, language and so on.

Some settings can only be changed when the recorder is stopped. During playback or recording these settings are

grayed out in the Initial Setup menu.

Except for the Setup Navigator, menu screens are exited automatically after 20 minutes of inactivity.

• Press HOME MENU and select ‘Initial Setup’.

In the table below, the default option is marked with a •.

Setting Options Explanation
Basic Settings
Clock Setting Auto
Set the channel that broadcasts a clock signal and the clock will be set
automatically.
Manual •
If there is no channel that broadcasts a clock signal in your area, you
can set the time and date manually.
• The clock must be set in order to use timer recording.
• When using EPG data download, the clock is set automatically and this setting is unavailable. To be able to use this setting again, reset the unit
to its default settings.
Help Setting On •
Switches on the automatic Help screens for GUI displays.
Off
Switches off the automatic Help screens for GUI displays. (Press
HELP
on the remote to manually display the Help screen.)
Setup Navigator Start
Select to start the Setup Navigator. See also

Switching on and setting

up

on page 25

.

Tuner Settings
Auto Channel Setting Antenna •
Select if you receive channels from an antenna. It takes a few
moments for the auto tuning to complete.
Cable
Select if you receive channels via cable. It takes a few moments for the
auto tuning to complete.
Manual CH Setting Next Screen
Proceed to the next screen if you need to adjust any of the settings
made by auto tuning.
• Change channels using the

CH +/–

buttons.
• To skip the displayed channel (because there is no station assigned
to that channel), change the
Skip
setting to
On
.
• To manually fine tune the channel, change the
AFT
setting to
Off
then adjust the
Level
setting.
• Note that you can’t use the Auto Channel Setting or the skip feature (in the Manual Channel Setting) after completing the TV Guide setting.
Video Out Settings
Component Video Out Interlace •
Select if your monitor/TV is not compatible with progressive-scan video.
Progressive
Select if your monitor/TV is progressive-scan compatible. Check the operating
instructions that came with your monitor/TV if you’re not sure.
DVR-530H_KU.book 92 ページ ２００５年６月８日　水曜日　午前１１時１６分