Pioneer F500BT operation manual Acquiring/Cataloging iPod music information, Out

	Chapter
Customizing preferences	13

!Built-in — Outputs the sound from the built-in speaker only.

!Preout — Outputs the sound from the

audio output terminal only.

pThis product’s audio output terminal is the mini-plug at the cradle’s cable end.

pWhen the navigation system is combined with ND-G500 (sold separately), select “Pre-

out”.

pWhen the headphone is connected, no sounds are output from both the built-in speaker and audio output terminal.

Acquiring/Cataloging iPod music information

If you always set the language other than “Eng- lish” on “Program language:”, this setting is unnecessary.

Unless [VR Catalog Mode] is turned off, this navigation system tries to acquire the informa- tion needed to operate iPod with voice com- mands. It may take a short period of time to transfer the information. Change the setting according to your usage.

The navigation system starts acquiring/catalo- ging music information (1) when the iPod is connected or when the system boots up while the iPod is connected and (2) when iPod is the selected and displayed AV Source, unless [VR Catalog Mode] is turned off.

pIf you do not use iPod, this setting is un- necessary.

pDuring transfer, iPod operations (such as [Shuffle], [Menu], or [Video]) are not available.

pOnce the cataloging is completed, you can deactivate [VR Catalog Mode] until you update the content/data on iPod. If you up- date the iPod data, activate [VR Catalog Mode] again to transfer the music informa- tion and synchronize the music information for voice commands with the data on iPod.

pAfter you select “Off” in [VR Catalog Mode], the system doesn’t catalog the

data on the iPod. In such case, the pre- viously cataloged data are available as voice commands.

pOnce you start the cataloging process, only a few basic voice commands can be used

for iPod until the process has completely finished.

pIf unreadable characters are included in the data on your iPod, names or types may not be available as voice commands.

Important Notice regarding Voice Control for iPods

Voice Control for iPods may be limited if cata- loging of iPod content is not completed. Cata- loging of iPod content only occurs when the system is in “AV Source” mode and the “iPod” is the selected and displayed AV source. Cata- loging of iPod content will not occur if the sys- tem is off, if any other “AV Source” is selected (aside from iPod), or if the system is in any other mode (aside from “AV Source” mode) such as “Destination” mode, “Contacts” mode, “Settings” mode, “Phone” mode or “Map” mode. If you wish to use Voice Control for all iPod content, it is recommended that you first connect your iPod, select “iPod” as the AV source, and keep the iPod screen displayed until cataloging is completed — cataloging of iPod content should only take a few minutes, and will depend on the size of the conent stored on your iPod. A message will be dis- played when cataloging is completed.

1Touch [VR Catalog Mode] on the “AV Settings” menu.

=For details, refer to Displaying the “AV Set- tings” menu on page 95.

2Touch [On] or [Off] to activate or deacti- vate “VR Catalog Mode”.

Customizing preferences

En 97