16
En
BEFORE USING
Remote Control Unit and Main Unit Preparations
Notes on using the remote control unit
Film
• Before using the remote control unit for the
first time, pull out the film from the back of the
remote control unit.
• Do not drop or step on the remote control unit
or subject it to shocks. Doing so may damage
it.
• Note that it may not be possible to operate the
remote control unit if there are obstacles
between it and the remote sensor.
• Do not expose the remote sensor to strong
light. Doing so may make operation
impossible.
• Use the remote control unit within the
specified operating range.
1
Insert your fingernails into
a
and
b
on the diagram below, press
a
in the direction of the arrow, then
pull out the battery holder.
2
Remove the old battery, then insert
the new battery into the battery holder
with the
ª
side facing upwards.
Replacing the battery
3
Fit the battery holder back into
place.
Lithium battery (CR2025)
CR2025
Note:
To prevent leakage of fluid from the lithium battery,
remove the battery when not using the remote control
unit for long periods of time (one month or more). If
the fluid should leak, carefully wipe any fluid out of the
battery case, then insert a new lithium battery.
WARNING
(lithium battery)
•Keep out of the reach of children.
•Contact a physician immediately if a
battery should be swallowed.
•Do not take apart, dispose of in flames,
charge, heat, solder or short-circuit.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Discard used batteries according to the
manufacturer’s instructions.