Getting started 02
9
En
English Français
Deutsch
Nederlands
Italiano Español
Chapter 2
Getting started
Home theater sound setup
Place your speakers as shown below for
optimal surround sound (see the Speaker
Setup Guide for more placement tips).
•
Standard surround 5-spot setup
– This is
a standard multichannel surround sound
speaker setup for optimal 5.1 channel
home theater sound.
XV-DV151 only:
Depending on the size and
characteristics of your room, you can choose
to use the following setup option:
1
•
Front surround 3-spot setup
– This setup
is ideal when rear surround speaker
placement isn't possible or you want to
avoid running long speaker cables in your
listening area. Use this setup together with
the Front Surround modes to take
advantage of wall and ceiling reflections
for a very realistic surround effect.
After placing your speakers, complete
Setting
the channel levels
below then refer to
Speakers
settings
on page 26 to complete your surround
sound setup.
Setting the channel levels
Set the relative channel levels from your main
listening position.
2
1 Press
TEST TONE
.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
•
L
– Front left speaker
•
C
– Center speaker
•
R
– Front right speaker
•
SR
– Right surround speaker
•
SL
– Left surround speaker
•
SW
– Subwoofer
3
2 Use the VOLUME +/– button to adjust
the volume to an appropriate level.
3 Use
/
to adjust the speaker levels in
turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
4When you’re done, press ENTER to exit
test tone setup.
Note
1When using this setup, make sure the front surround mode is switched on (page 14) before selecting any surround mode.
Front left
Surround
left
Listening position
Center
Subwoofer
Front right
Surround
right
Front
left
Front
right
Surround
left
Surround
right
Listening position
Center
Subwoofer
2• This is only available when
DVD/CD
is selected and playback is stopped. Also make sure headphones are unplugged.
• To adjust the overall balance while listening to any sound source you want, press
SETUP
, use
/
to select
CH LEVEL
then
press
ENTER
. Use
/
to move channel to channel, and
/
to adjust the channel levels. Press
ENTER
when you’re finished.
3Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
XV-DV151_252.book 9 ページ ２００６年２月２４日　金曜日　午後２時０分