HDD Install/Remove

The NAS-7100 supports one 3.5-inch Serial-ATA (SATA) hard drive. NAS-7100 does not support low profile or half high hard drive.

HDD Install

1.Make sure the NAS-7100 is powered off

2.Open top cover of NAS-7100

3.Make sure your hard drive is SATA interface and make sure you back up all pre- existing data before use it on NAS-7100

4.Pull up the HDD tray then slide and push the HDD into the tray, make sure con- nector well connecting

5.Push down the HDD tray

6.Put the top cover of NAS-7100 back to finish HDD install

HDD Remove

1.Make sure the NAS-7100 is power off

2.Open top cover of NAS-7100

3.Pull up the HDD tray,

4.Pull out the HDD till SATA connector release then the HDD can slide out of HDD tray