Printronix LQH-HWTM manual Matrix Command Format, Default value is 0.9-inch

Matrix

Matrix Command Format

BARCODE

MATRIX [CD]; [DIR;] [MAG;] [Hn[.m];] [BFn;L;] [DARK;] SR; SC [(D)data field(D)]

[PDF [;LOC] [;FONT]]

STOP

BARCODE The Bar Code command; enter BARCODE.

MATRIX CD Designates bar code type Matrix; enter MATRIX. To calculate and plot the optional modulo-10 check digit with the bar code symbol automatically, enter CD.

DIR	Optional parameter that allows for rotating a
	barcode. Enter CW for clockwise rotation. Enter
	CCW or VSCAN for counter-clockwise rotation.
	Enter INV for inverted rotation. If DIR is not
	entered, the barcode is horizontally oriented.
MAG	Optional parameter to magnify (horizontally
	expand) the bar code symbol. The magnification
	default value is X1. As required for scanning, enter
	a magnification value from Table 8 to increase the
	magnification. Increasing the magnification adjusts
	printed character density. You can also use XR or
	XRD, defined on page 89.
Hn[.m]	Optional parameter to adjust the overall height
	(vertical expansion) of the bar code symbol
	(including the upper and lower 0.1-inch guard
	bands and any human readable data). Height
	adjustments are made in 0.1-inch increments; enter
	H and a value from 3 through 99 to select height
	adjustments from 0.3 through 9.9 inches. The
	default value is 0.9-inch.
	[.m] is an additional number of dots for the bar code
	height. (Dots are in the current dot scale.)

Note If 0.3 inches is the selected height, the PDF cannot be included.

BFn;L Optional parameters for assigning a dynamic bar code data field location on a form and for designating the length of the data field. With these parameters, the actual data for the bar code data field is dynamically provided during the Execute Form Mode; the data is not specified during the Create Form Mode. To use this field, perform the following steps:

a.Enter BF.

143