Profile BA400, BA440 P

At times, the amplifier will need to draw large levels of current that cannot be provided by any

circuit in the car's fuse box. We recommended using an 10 to 12 gauge power wire for your

connections depending on the amplifier and length of the wire. Strip one end of the wire to

connect to the terminal on the amplifier marked +12V. Loosen screw terminal and connect

bare wire and tighten. Use caution to make sure no stray wire stands come in contact with

surrounding terminals causing short circuits. Run the wire directly to the positive terminal of

the car's battery. Make sure to use an in-line fuse within 12" of the car's battery to protect

the electrical system and amplifier against short circuits and/or power surges.

For the ground connection, use an 10-12 gauge wire (black) to connect to the terminal marked

GND and then connect it to the car's chassis. Try to keep the length of the cable as short as

possible, preferably less than 6". Also make sure that the point on the car where the

connection is to be made is free of paint and dirt.

This connection allows the amplifier to be turned on and off with the power control of the

radio. If the radio has a Remote output wire, connect it to the amplifier's terminal marked

REM (using a 16 gauge wire or heavier). Now when the radio is turned on, the amplifier will

automatically turn on. This connection can also be made to the radio's Power Antenna wire.

IMPORTANT! Before making any connections, disconnect the car's battery until the

installation is completed to avoid possible damage to the electrical system.

POWER CONNECTIONS

CAR BATTERY

+12V

CAR BATTERY

+12V

94.794.7

RADIO'S REMOTE

TURN-ON OUTPUT

RADIO'S REMOTE

TURN-ON OUTPUT

IN-LINE POWER FUSE

MOUNTED WITHIN 12"

FROM BATTERY RECOMMENDED

(SAME RATING AS ON THE AMP)

IN-LINE POWER FUSE

MOUNTED WITHIN 12"

FROM BATTERY RECOMMENDED

(SAME RATING AS ON THE AMP)

(NOT PROVIDED)(NOT PROVIDED)