3)Support strap (supplied)

Before installing the receiver permanently, fit it in the approximate place in your car ,and connect the equipment according to the speakers and electrical connections. When

your system is operated properly,(preferably with the car engine running), follow the instructions

for permanent installation of your system.

1)Install half sleeve, can be with or without adapter. It will fit better with adapter.

2)Bend over some tabs to secure the half sleeve inside of dash.

3)Support strap to be strutted under dash, secure this strip to avoid skipp ing of disc.

Insert removal wrench into the small gap on the right side of the unit and pull the unit slightly out on the same side, then release the wrench. Repeat the same action for the left side. By now, you can remove the unit and unplug the wires connector.

2)Bend over tabs of half sleeve (supplied)

4)Two wrenches for releasing the unit (supplied)

1)Adapter (not supplied)

Half sleeve (supplied)

4