Radio Shack 26-751 manual

!"#$

www.radioshack.comSM

OWNER’S MANUAL —	26-751
Please read before using this equipment.

•	Keep your previous mouse installed as a
	back-up until you finish installation.
• Do not use the mouse on a desk made of
	glass, mirror, iron, or black velvet. A flat
	surface is necessary or the optical sensor will
	not work.
•	For optimal performance, place the receiver
	at least 8 inches (20 centimeters) away from
	other electrical devices, such as the
	computer, the computer monitor, speakers,
	or other external storage drives.
•	For normal transmit distance, avoid using this
	device on a metal surface because a large
	surface of iron, aluminum, copper or other
	metal will be a shielding or ground to the

Receiver

USB Connector

Receiver Antenna

LED — Lights green when	Mouse
the mouse is moved.

USB to PS2 Adapter — Lets you use your mouse with computer either with PS2 or USB connector.

LED — Flashes red when battery power weakens.

Scroll Wheel — Lets you scroll and select quickly and easily.

mouse’s RF antenna and receiver.

• If your notebook computer has a metal

(contains aluminum or magnesium) case, the

LCD panel’s metal housing will isolate partial

power of the RF signal from the mouse. This

will result in reducing the transmitting

distance when you connect the receiver on

the back of the LCD panel; however, your

mouse should work properly while using it

beside your notebook computer.

System Requirements

Thank you for purchasing the Compaq 27MHz Wireless Combo Optical Mouse. Your mouse’s advanced RF (Radio Frequency) technology enables 360° operation. Its optical sensing technology creates precise, smooth movement, with no moving parts to clean or replace. You do not need to aim at the receiver when using the mouse. The 5-button design lets you assign button functions and use your mouse with other computer accessories. The supplied driver CD provides customized functions for operation with Windows.

connect the PS2 connector to the PS2 port.

PS2 USB

Hardware — IBM PC or compatible with one available USB or PS/2 port and a CD drive.

Software — Microsoft Windows 95, Windows 98, Windows 2000, Windows ME, or Windows XP.

Battery Installation

•When the mouse battery power weakens,

the red LED on the receiver flashes and the eyes of flash red.

•You need to set the channel every time you replace the batteries. See “Hardware Installation”.

Hardware Installation

•Always turn off your computer before you connect or disconnect your mouse unless you are using a USB device with Windows 98 or above.

•You can only set up one wireless optical mouse at a time. If you have additional wireless optical mouse sets within 10 square meters, interference occurs between the receiver and your mouse. Relocate the mouse beyond this distance.

1.Remove the battery compartment

cover from the back of the mouse.

2. Insert two AA batteries (not supplied).

3.Replace the

battery compartment cover.

1.Turn off your computer.

2.If your computer has a USB port, connect the receiver’s USB connector to the USB port.

If your computer’s mouse port is a PS2 type, connect the USB to PS2 adapter to the receiver’s USB connector. Then

3.Turn on your computer.

4.Press the channel button on the back of the receiver. Then press the channel button on the back of the mouse to activate it.

Back of receiver

Channel Buttons

Back of mouse

5.If interference becomes a problem, press both channel buttons again to change channels.

1.Make sure the mouse receiver is connected to the computer.

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

— Important

— Note

RadioShack and RadioShack.com are trademarks used by

RadioShack Corporation.