STORING A NUMBER IN MEMORY

1.Lift the handset.

2.Press MEMORY. TALK/BATT blinks.

3.Enter the number and any tone and pause entries (see “Using Tone Services on a Pulse Line” on Page 8 and “Entering a Pause” on Page 9). Ô

4.Press MEMORY again, then enter the memory location number (0–9) where you want to store the number. A tone sounds to indicate that the number is stored.

To replace a stored number, simply store a new one in its place. Or, lift the handset and press MEMORY twice. Then press the memory location number (0–9) you want to clear. A tone sounds.

ENTERING A PAUSE

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, you should also store a pause after the access code to allow the outside line time to connect. To enter a 2-second pause, press REDIAL/PAUSE. You can add more pause entries for a longer pause.

DIALING A MEMORY NUMBER

To dial a number stored in memory, lift the handset and press TALK. TALK/BATT lights. When you hear a dial tone, press MEMORY and enter the memory location number for the number you want to dial.

To dial a number stored in memory location 1, press SPEED DIAL. You do not have to press TALK when you press

SPEED DIAL. ÔCHAIN-DIALING SERVICE NUMBERS

For quick recall of numbers for special services (such as bank-by-phone), store each group of numbers in its own memory location.

Dial the service’s main number first. Then, when prompted to enter the number, press MEMORY and enter the number for the location where the additional information is stored.

TESTING STORED EMERGENCY NUMBERS

If you store an emergency service’s number (police department, fire department, ambulance) and you choose to test the stored number, make the test call during the late evening or early morning hours to avoid peak demand periods. Also, remain on the line to explain the reason for your call.

Ô NOTE Ô

Storing a Number in Memory

•An error tone sounds and the phone exits the programming mode if you wait more than 30 seconds between keypresses.

•Each tone or pause entry uses one digit of memory.

•If you try to enter more than 16 digits, the phone beeps 5 times and exits the programming mode. Start over at Step 2 and enter no more than 16 digits in Step 3.

Dialing a Memory Number

If you select an empty memory location, the phone beeps 5 times.

Operation

9