I N S T A L L A T I O N
IMPORTANT:
This product must be installed in accordance with your local area’s building codes and regulations. This may require use of an additional support bracket, depending on the installation. In this case, use the MBR-70 described below.
SEISMIC TAB:
For proper installation, the seismic tab MUST be secured to a secondary support in the event of failure of the primary support structure.
MBR-70:(sold separately)
The MBR-70 consists of a round bracket and two rails designed to be used with suspension ceilings. The rails will fit either 24” or 600mm tiles. They are designed to rest on top of the tile without the “V” end of the rail grabbing the grid struts. In the event that the tile falls, the “V” end of the rail will grab the strut holding the speaker in place. The MBR-70 is not required for installation when the speaker is being installed in drywall or other rigid material. When installing in these surfaces, use attached swivel mounts and hole locating template included in the box with each loudspeaker.
For suspension ceiling installation instructions, refer to the installation manual included with the MBR-70.