���������������
���������� | ��������������� | ��������� |
|
|
|
��������������������������� | Amplifier is not connected to constant A.C. | Make certain that the amplifier is plugged into |
| power outlet. | an unswitchable A.C. power outlet. |
|
|
|
| Subwoofer(s) is/are not connected to amplifier | Make certain that subwoofer(s) is/are conn- |
| correctly. | ected properly (refer to the connections section |
|
| of this manual). |
|
|
|
| Amplifier is not receiving an audio signal from | Make certain that there is an audio signal from |
| ||
|
| resemble those in the connections section of |
|
| this manual. |
|
|
|
| Electrical short in wiring. | Verify that all connections are complete and |
|
| secure, with no stray wires contacting other |
|
| terminals. |
|
| If problem is in wire itself, replace suspect wire. |
|
|
|
| Amplifier fuse might be blown. | Replace fuse( if fuse is not readily accessible, |
|
| consult your authorized RBH dealer.) |
|
| Warning: Before replacing fuse, please see |
|
| the rear panel features/controls section (#14) |
|
| of this manual. |
|
|
|
��������������������������������������� | Bad connection(s) to non working subwoofer(s). | Verify that all wires are properly connected. |
����������������� |
|
|
|
|
|
| Electrical short in wiring. | Verify that all connections are complete and |
|
| secure, with no stray wires contacting other |
|
| terminals. |
|
| If problem is in wire itself, replace suspect wire. |
|
|
|
| If one subwoofer is damaged due to being | Check each individual subwoofer to verify that |
| overdriven, then it may have a negative effect on | each is still operational. |
| another subwoofer used in a series connection. |
|
|
|
|
���������������������������������� | The + and - polarity of the subwoofer wire might | Check the entire system for proper polarity. |
| be reversed on the subwoofer. |
|
|
|
|
| Crossover frequency not adjusted correctly. | Adjust crossover frequency by turning the |
|
| Crossover Frequency Control clockwise until |
|
| desired sound is obtained. |
|
|
|
| Crossover switch is in the wrong position. | Check Crossover On/Off switch for correct |
|
| setting. |
|
|
|