Setting Up the VCR
Startup
Set the Clock
If the AUTO CLOCK SET was unsuccessful, set the clock through the menu option. Also, if you choose to set the clock manually, the AUTO CLOCK SET feature is automatically turned off.
A. Press MENU on the remote to display the VCR MAIN MENU.
B. Press 3 to display the TIME menu.
C. Press 1 to display the SET TIME AND DATE.
D. Use the number buttons on the remote to enter the time including AM or PM, month, day, and year. The day of the week will automatically appear after you enter the year.
•Press 0 before
5:07 PM.
•Press CLEAR on the remote at any time to change incorrect entries.
E.Press MENU to set the clock.
F.Press 0 to exit the menus.
The time appears in the VCR’s display panel. To display the time and date on the screen, press DISPLAY on the remote.
Auto Channel Search
The AUTO CHANNEL SEARCH feature memorizes the channel list available through your signal
Should you change your signal system, you must perform Auto Channel Search again.
Wait until the channel numbers stop changing. This takes about one to two minutes. The TV tunes to the lowest channel found. Pressing CHANNEL up or down selects only the active channels.
A. Press MENU on the remote to display the VCR MAIN MENU.
B. Press 4 to display the CHANNELS menu.
C. Press 1 to begin AUTO CHANNEL SEARCH.
The VCR automatically selects the CABLE (cable TV) or ANTENNA signal. For cable connection, 125 channels are searched; for an antenna connection, 69 channels are searched.
To change the SIGNAL TYPE:
A. Follow steps
B. Press 3 to switch the SIGNAL TYPE between CABLE and
ANTENNA.
VCR MAIN MENU 1 VCR PLUS+
2 TIMER RECORDINGS
3 TIME
TIME
1 SET TIME AND DATE
SET TIME AND DATE
TIME 
--:--
DATE
SET TIME AND DATE
TIME 02:30 PM (HH:MM)
DATE 08/04/96 SUNDAY
PRESS CLEAR TO CORRECT PRESS MENU TO SET
VCR MAIN MENU 1 VCR PLUS+
2 TIMER RECORDINGS
3 TIME
4 CHANNELS
CHANNELS
1 AUTO CHANNEL SEARCH
AUTO CHANNEL SEARCH
NOW SCANNING CHANNEL 1
PRESS ANY KEY TO CANCEL
13