REI VPC-64, VPX-64 USING THE VIDEO POLE CAMERA

REI VPC/VPX 6

USING THE VIDEO POLE CAMERA

1. Remove the main body of the Video Pole Camera, which includes the pole and

monitor, from the case.

2. Remove the camera from the case

3. Place the camera on the pole such that two connectors align. There is a tab in

the connector on the pole and a slot in the connector on the camera.

4. Push and rotate the locking ring, located on the camera’s connector.

5. Place a battery pack in the battery holder with the cable away from the pole and

towards the foam grip.

6. Plug the battery connector into the DC Power IN Jack.

1. Turn the monitor on by pressing the Power Switch.

2. Remove the lens cap from the camera.

3. Adjust the color saturation, contrast and brightness to obtain a desired video

image.

4. The monitor may be tilted and rotated as needed to allow better viewing of the

video image.

5. If desired or in low light conditions the LED illumination can be turned on. To turn

the LED illumination on press the Illumination Switch. The illumination brightness

may be adjusted by the Illumination Brightness control.

The camera may be manually tilted using the outer pins on the camera body. The

camera can be tilted +90 degrees to -25 degrees.

Because the Video Pole Camera can be used in many different conditions the

camera may require focusing. Focusing is a manually adjustment. To focus the

camera, rotate the lens by grabbing the outer ring of the lens. Avoid touching the

clear part of the lens.

In addition to the lens that is shipped on the camera, other lenses are supplied. To

switch lenses, unscrew the lens on the camera. Then screw the new lens on the

camera. Take care to keep any dust or foreign objects out of the camera while the

lens is off. The camera should have a lens installed at all times, including during

non-use periods.