®
ELECTRIC CHAIN SAW
CLEANING AND MAINTENANCE
NOTICE: Below are instructions for servicing your chain saw. Any servicing not mentioned below should be done by an authorized service center.
CLEANING SAW BODY
WARNING: Unplug chain saw from power source before servic- ing. Severe injury or death could occur from electrical shock or body contact with moving chain.
WARNING: Cutting edges on chain are sharp. Use protective gloves when handling chain.
WARNING: When cleaning saw body,
•do not submerge saw in any liquids
•do not use products that con- tain ammonia, chlorine, or abrasives
•do not use chlorinated clean- ing solvents, carbon tetrachlo- ride, kerosene, or gasoline
Keep saw body clean. Use a soft cloth damp- ened with a mild soap and water mixture. Wipe saw body to clean.
CARE OF GUIDE BAR
Uneven bar wear causes most guide bar problems. Incorrect sharpening of chain cutter and depth gauge settings often cause this. When bar wears unevenly, it widens guide bar groove (see Figure 18). This causes chain clatter and rivet popping. Saw will not cut straight. Replace guide bar if this occurs.
Inspect guide bar before sharpening chain. A worn or damaged guide bar is unsafe. A worn or damaged guide bar will damage chain. It will also make cutting harder.
Guide Bar
Groove
Guide Bar
Normal Guide | Guide Bar | |
With Uneven | ||
Bar | ||
Wear | ||
|
Figure 18 - Guide Bar Cross Section Show- ing Uneven Bar Wear
Normal Guide Bar Maintenance
1.Remove guide bar from chain saw.
2.Remove sawdust from guide bar groove periodically. Use putty knife or wire.
3.Clean oil slots after each day of use.
4.Remove burrs from sides of guide bar. Use flat file to make side edges square.
Replace guide bar when
•bar is bent or cracked
•inside groove of bar is badly worn
Note: When replacing guide bar, see Re- placement Parts and Accessories, on back cover, for proper bar.
Burr
Flat File
Guide Bar
Cleaning Groove With
Putty Knife
Oil Slot
Figure 19 - Guide Bar Maintenance
12 | 097017 |
