Section 2 Connection Procedures
WARNING Always switch OFF the user system and the emulator
product before the EXPANSION BOARD or USER SYSTEM
INTERFACE CABLE is connected to or removed from any
part.
Before connecting, make sure that pin 1 on each side
is correctly aligned. Failure to do so will result in a FIRE
HAZARD and will damage the user system, the emulator
product, the user system interface cable, and the expansion
board, or will result in PERSONAL INJURY. The USER
PROGRAM will be LOST.
2.1 Using Emulator without Connecting User System
1. Make sure the emulator is turned off.
2. After making sure the direction of the expansion board connector labeled E6000 EMULATOR
is correct, firmly insert the expansion board connector into the emulator station connector. When
the emulator is operated while connected to only the expansion board (without connecting the
user system), disconnect the cable body from the expansion board.
2.2 Using Emulator with Connecting User System through User System
Interface Cable
CAUTION
When connecting or removing the user system interface
cable, apply force only in the direction suitable for
connection or removal, while making sure not to bend or
twist the cable or connectors.
Otherwise, the cables or connectors will be damaged.
1. Make sure the emulator and the user system are turned off.
2