Manuals / Brands / Personal Care / Sleep Apnea Machine / ResMed / Personal Care / Sleep Apnea Machine

ResMed VPAP Auto 25 VPAP ST VPAP S Using the VPAP Auto 25, VPAP ST & VPAP S

1 22

Download 22 pages, 374.26 Kb

3Using the VPAP Auto 25, VPAP ST & VPAP S

English

Supplemental Oxygen

The VPAP Auto 25, VPAP ST and VPAP S are designed to be compatible with the

following levels of supplemental oxygen usage:

•Up to 4 L/min in VAuto mode

•Up to 15 L/min in CPAP, S, ST and T modes.

At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration

will vary, depending on the pressure settings, patient breathing pattern, mask

selection, and the leak rate.

!

WARNING

Always use the ResMed Oxygen Connector Port when adding supplemental

oxygen at the flow generator outlet.

Using the VPAP Auto 25, VPAP ST & VPAP S

Setting up your VPAP

1Connect the power cord to the socket at the rear of your VPAP.

2Plug the other end of the power cord into the power outlet.

3Connect one end of the air tubing firmly onto the air outlet.

4Connect the assembled mask system to the free end of air tubing.

For information on assembling your mask, see your mask manual.

!

WARNING

•Make sure the power cord and plug are in good condition and the

equipment is not damaged.

•Only ResMed air tubing should be used with the device. A different type of

air tubing may alter the pressure you actually receive, reducing the

effectiveness of your treatment.

•Blocking the hose and/or air inlet of the device while in operation could lead

to overheating of the device.

1

2

34

Contents

Main VPAP Auto 25 VPAP ST VPAP S POSITIVE AIRWAY PRESSURE DEVICE User Guide English Contents 1Introduction Introduction Contraindications Adverse Effects CAUTION (USA ONLY) The VPAP System Masks Humidifier ResScan Data Card 3Using the VPAP Auto 25, VPAP ST & VPAP S Supplemental Oxygen Using the VPAP Auto 25, VPAP ST & VPAP S Setting up your VPAP 1 2 3 4 4 CAUTION Attaching a H4i Humidifier How to Use the Control Panel 5Using the VPAP Auto 25, VPAP ST & VPAP S Using the Menus 1 2 3 How to Select the Mask Type How to change the EPR level (CPAP mode) 1 2 3 4 How to change the Exhalation rate (VAuto mode) 1 2 3 4 Starting Treatment 1 2 3 4 5 6 Stopping Treatment Using the Mask-Fitting feature 1 2 Reminders on the VPAP LCD ***** Using the Data Card Copying Data onto a Data Card Updating Settings on your VPAP 10 Traveling with the VPAP Auto 25, VPAP ST & VPAP S International Use Use on an Aircraft Use with DC Power Cleaning and Maintenance Daily Weekly Monthly Replacing the Air Filter Servicing CAUTION 13Troubleshooting Troubleshooting No display Insufficient air delivered from the VPAP device Device does not start when you breathe into the mask Device does not stop when you remove your mask Problem/Possible Cause Solution Page 15Technical Specifications Technical Specifications Note: The manufacturer reserves the right to change these specifications without notice. Symbols Which Appear On The Device General Warnings and Cautions Warnings Cautions 17General Warnings and Cautions Guidance and Manufacturers Declaration Electromagnetic Emissions and Immunity Guidance and manufacturers declaration electromagnetic emissions Emissions test Compliance Electromagnetic environment guidance Separation distance according to frequency of transmitter (m) Guidance and manufacturers declaration electromagnetic immunity Immunity test IEC60601-1-2 test level Compliance level Electromagnetic environment guidance 19Limited Warranty Limited Warranty