Ricoh AP2610N setup guide Job Spool Setting, Clearing Spool Job, Changing the Host Name

Appendix

❖Job Spool Setting

msh> spoolsw spool {on off}

Note

❒ Specify "on" to enable the job spool function or "off" to disable it.

❖Clearing Spool Job

If the printer is turned off accidentally during a spool job, you can specify whether the job will be reprinted when the printer is turned back on.

msh> spoolsw clearjob {on off}

❖Protocol Configuration

To change the protocol settings, use the following command. You can specify the setting for [lpr] or [ipp].

•lpr

msh> spoolsw lpr {on off}

•ipp

msh> spoolsw ipp {on off}

Changing the Host Name

	Use the hostname command to change the printer name.
7	msh> hostname [interface_name ] printer_name
	interface name	Interface to be configured
	ether	Ethernet interface *1
	wlan *2	IEEE 802.11b interface
	ip1394 *3	IEEE 1394 interface

*1

*2

*3

If you did not enter the interface name, it will be automatically set to the Ethernet in- terface.

If you install the 802.11b Interface Unit Type A, you can set the command. If you install the 1394 Interface Unit Type 4510, you can set the command.

Note

❒Enter the printer name using up to 13 characters.

❒You cannot use a printer name starting with RNP or rnp.

❒The Ethernet interface and IEEE 802.11b interface will have the same printer name.

104