Rimage EverestTM Printer # Tip: If all indicator lights are blinking, the printer did not initialize properly. To , # Tip: To put the printer into sleep mode, press

Rimage Everest Printer
4 110632_L
Control panel
The control panel, located on the front of the printer, includes an operator button
and four indicator lights. The control panel allows you to monitor and control the
Everest printer.
# Tip: If all indicator lights are blinking, the printer did not initialize properly. To
correct this issue:
1. Remove the power cord. The Everest printer powers down.
2. Set the mode switch to the proper position. For more information, refer to
the table on page 6.
3. Reconnect the power cord. The Everest printer powers on.
Image Name Functionality
Operator Button The operator button is used to complete the
following tasks:
• Open the printer drawer
• Close the printer drawer
• Reset after an error
• Put the printer in sleep mode
# Tip: To put the printer into sleep mode, press
and hold the operator button for 10
seconds. Press the operator button again to
resume normal operation.
The error indicator light, located on the operator
button, illuminates when operator action is required.
Error indicator light
CD Present indicator light The CD present indicator light illuminates when a
CD is placed on the drawer or when the CD is
properly clamped.
The CD present indicator light flashes when an
Everest print latch is open or a ribbon is not
detected.
Active indicator light The active indicator light illuminates when the
printer has completed initialization.
The active indicator light flashes when the Everest
printer is receiving data from the host.
The power indicator light illuminates when the
Everest printer is powered on.
Power indicator light