Connecting to your computer network - cont.
If your network allows automatic configuration (which is normal) the radio will acquire a network address. The screen should say 'Connecting...', and then 'Setup wizard completed'. Press the Tuning/Select control to exit the setup wizard and show the main menu. You can then skip to paragraph 18 overleaf.
There are two indicator lights incorporated into the
Green ON = Link established; OFF = no connection
Green Flashing = Data transfer
Yellow ON = 100 Mbits/sec link; OFF = 10 Mbits/sec link
If your network does not support automatic configuration or if you wish to set it up manually then you should select '[Manual config]' instead of selecting '[Wired]' in the Network Wizard, then see page 16.
11.If you plan to use a WiFi connection, you will first need to identify your network in the list of network names presented by the Network Wizard. If no networks are found then you may have to get your wireless router working (please see the instructions supplied with it) or you may be too far from the router.
When the radio finds your wireless network, it displays the Network Name (SSID) for the wireless access point on the screen. This is a name that is allocated to the access point in your router by the person who set up the network - for example: 'Jones family' or 'Paul's network'. If the router supports WiFi Protected Setup, then '[WPS]' will be shown in front of the SSID.
It is possible, and in some locations highly likely, that your radio will find more than one wireless network, in which case you should choose which one you need to connect to.
12.Rotate the Tuning/Select control to see the SSID for each wireless network that has been found. If your network is shown proceed to step 14 on the next page. If it is not shown then proceed to step 13.
If you make a mistake at any point, use the Back option to go back to the previous screen.
11,12
12
Configuration
If you need any further advice, please call our Technical Helpline on 020 8758 0338 | 12 |