RF-TRP47CI 47" Carbon Fiber Tripod
Quick Setup Guide
•Tripod with pan head
Note: mounting plate is on the pan head.
•Quick Setup Guide
Important safety instructions
•Make sure that all levers, handles, knobs, and leg locks are correctly tightened, and that all three legs are fully opened before use.
•Do not carry or transport the tripod with camera or camcorder equipment attached (for example, over your shoulder or cradled in your arms).
•Do not store or expose your tripod to excessive heat or cold, or use near any flame or fire.
•Do not oil or grease any part of the tripod.
•Do not use any solvents or thinners to clean your tripod.
Use only a mild detergent and wipe dry with only a soft,
•Do not exceed the load limit of this product. (See Specifications)
Mount your device to this removable plate.
Tighten to secure your device to the mounting plate.
Mounting base plate
Variable angle head ball
Allows the head to be adjusted to any angle.
Safety lock pin
Prevents the mounting plate from falling out when the
Pan locking knob
Locks the horizontal movement of the head.
Head ball locking knob
Sets the head at different angle. Loosen to permit movement
of the head ball. Tighten to stop movement of the head ball.
Using your tripod
To set up your tripod:
1Unscrew the leg locks on each leg (three per leg) and extend the legs to the
2Tighten the leg locks to lock the legs at the selected length.
Caution: Incorrectly securing a leg lock can cause the tripod leg to retract
unexpectedly and could result in damage to the tripod or to the attached camera or camcorder.
3Press the variable leg angle release at the top of each tripod leg to spread the legs to the first preset angle. When each leg has been locked into the first preset angle, set the tripod on a firm surface.
4Adjust the center column by unscrewing the center column lock, raising the center column to the desired height, then tightening the center column lock.
5To remove the mounting plate, unscrew the
quick-release plate locking knob,
then press the safety lock pin and lift the plate away from the head.
6Secure your camera or camcorder to the mounting plate with the 1/4" screw on the bottom of the plate. Tighten the screw firmly to avoid unintended lateral movement of your device.
Center column lock
One-year limited warranty
Visit www.rocketfishproducts.com for details.
For customer service please call
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richfield, MN
©2010 BBY Solutions, Inc., All Rights Reserved. ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and brand names are trademarks of their respective owners.
Best Buy Imports, S. de R.L. de C.V. Av. Santa Fe 485, Segundo Piso, Colonia Cruz Manca, Programa Parcial de Desarrollo Santa Fe, Delegación Cuajimalpa, Distrito Federal, México 05349
©2010 Best Buy UK Distributions Limited. All rights reserved. Distributed by Best Buy Europe Distributions Limited. 1 Portal Way, London W3 6RS