81
Connecting an External MIDI Device
You can connect external MIDI devices to the JUNO-Di’s MIDI OUT
connector, and use the JUNO-Di to control the connected MIDI devices.
Connection Example
fig.midi-control-e.eps
1.
Press the [MIDI CONTROLLER] button so it’s lit.
The “MIDI CONTROLLER” screen will appear, and the JUNO-Di will be
in MIDI Controller mode.
If MIDI Controller mode is selected, you can perform the following
operations on the JUNO-Di.
• When you press one of the [0]–[9] buttons, the program change
message assigned to that button will be transmitted.
• You can turn the SOUND MODIFY knobs to transmit control change
messages.
The note numbers transmitted in MIDI controller mode are
determined by the key you press, the transpose setting (p. 44),
and the octave shift setting (p. 34) you specify in MIDI
controller mode.
You can use the arpeggio (p. 37) and chord memory (p. 37)
functions even when you’re in MIDI Controller mode.
2.
To exit MIDI controller mode, press the [MIDI
CONTROLLER] button to turn off the button’s
illumination.
The D Beam controller will not operate when you’re in MIDI
controller mode.
Set the JUNO-Di’s transmit channel so it matches the channel your
external MIDI device is using for reception.
1.
In the “MIDI CONTROLLER” screen, use the [ ] button
to move the cursor to the “MIDI Ch” value.
2.
Use the dial to edit the value.
Value:
1–16
For details on how to set the receive channel of your external
MIDI device, refer to its owner’s manual.
fig.disp-midicont.eps
1.
In the “MIDI CONTROLLER” screen, use the [ ] [ ]
buttons to select the parameter that you want to edit.
2.
Use the dial to edit the value.
The changes you make to these settings will be saved when
you exit MIDI controller mode.
Using the JUNO-Di as a Master Keyboard (MIDI Controller Mode)
MIDI OUT
MIDI IN
MIDI sound module
JUNO-Di
Specifying the Transmit Channel
Detailed Settings in MIDI Controller Mode
Item Value Description
MIDI Ch
1–16
Specifies the channel on
which MIDI messages
will be transmitted.
Local Sw
OFF, ON
Specifies whether MIDI
messages will be sent to
the JUNO-Di’s own
internal sound generator
when you operate the
JUNO-Di.
PC
1–128
Specifies program
change number that is
transmitted.
MSB
0–127, OFF (If you specify
“OFF,” the LSB will also be
“OFF.”)
Specifies bank select
MSB that is transmitted.
LSB
0–127, OFF (If you specify
“OFF,” the MSB will also
be “OFF.”)
Specifies bank select LSB
that is transmitted.
Knob
ATTACK,
RELEASE,
REVERB,
CUTOFF,
RESONANCE
Selects the SOUND
MODIFY knob for which
you’ll make a controller
assignment.
Knob Assign
CC01–31,
CC33–95,
PITCH BEND,
AFTERTOUCH
Specifies the controller
assignment for the
selected SOUND MODIFY
knob.
JUNO-Di_e.book 81ページ ２００９年６月２２日 月曜日 午前９時２３分