Rosewill RNX-MiniN2 FAQ

Wireless N Adapter RNX-MiniN2 User Manual

FAQ

This chapter provides solutions to problems that may occur during the installation

and operation of the Wireless USB Adapter. Read the descriptions below to solve your

problems.

Reinsert the Wireless USB Adapter into your PC’s USB slot. Right click My

Computer and select Properties. Select the device manager and click on the

Network Adapter. You will find the Adapter if it is installed successfully. If you see

the yellow exclamation mark, the resources are conflicting. You will see the

status of the Adapter. If there is a yellow question mark, please check the

following:

Make sure that you have inserted the right adapter and installed the proper driver.

If the Adapter does not function after attempting the above steps, remove the

adapter and do the following:

Uninstall the driver software from your PC through Control Panel’s “Add or

Remove Programs”.

Restart your PC and repeat the hardware and software installation as specified in

this User Guide.

Make sure that the PC to which the Adapter is associated is powered on.

Make sure that your Adapter is configured on the same channel and with the

same security options as with the other computers in the Infrastructure

configuration.

Check that the LED indicators for the broadband modem are indicating normal

activity. If not, there may be a problem with the broadband connection.

Check that the LED indicators on the wireless router are functioning properly. If

not, check that the AC power and Ethernet cables are firmly connected.

Check that the IP address, subnet mask, gateway, and DNS settings are

correctly entered for the network.

In Infrastructure mode, make sure the same Service Set Identifier (SSID) is

specified on the settings for the wireless clients and access points.

In Ad-Hoc mode, both wireless clients will need to have the same SSID. Please