5
INSTALLATION
Attaching the Speaker
1. Place the disc spring washers over the socket head
screws with the convex sides against the screw heads.
2. Thread the socket head screws into the mounting
bracket. Leave at least ΒΌ inch (6 mm) of space
between the washers and the bracket ends.
3. Align the slots on the ends of the speaker with the
screws and slide the speaker fully onto the bracket,
pushing any excess cable back into the wall. Make
sure the washers are between the screw heads and the
speaker ends. Finger tighten the screws.
4. Aim the speaker according to the guidelines given in
the previous section on speaker placement.
5. Tighten the screws with the hex key provided.
6. Press the end caps into place.
Changing the Grille
The LCR7 comes with two different grilles, one of which
is attached to the speaker. To remove the grille:
1. Starting in one corner, insert the grille removal tool
into the edge of the grille and gently pull it slightly
away from the speaker. Continue along the short di-
mension and then around the entire edge of the grille.
Do not pull the grille completely off the speaker until
the edge is loosened all the way around.
2. When the entire edge is loosened, grasp the grille by
the edges and gently pull it off the speaker evenly.
Avoid bending the grille.
To attach the grille:
1. Align the edge of the grille with the recess in the
speaker cabinet.
2. Gently push the grille in place evenly around the
edge. Do not push on the center of the grille.
Rotating the Logo Badge
The logo badge is permanently attached to the grille,
but can be rotated to accommodate both vertical and
horizontal speaker orientations. To rotate the badge,
simply pull it straight away from the grille and turn it.