Front Callouts

1

2

3

5

2

45

1.Power Switch - Use this switch to power the MXS amplifier on or off

2.Channel Level Controls - Two detent controls to precisely adjust and the match the output level of each channel

3.MODE Indicators - The corresponding indicator lights based off of the setting of the rear panel MODE switch (Stereo, Bridge, Parallel).

4.FILTER Indicators - These LED indicators light depending on the setting of the rear panel FILTER switch (Full, 28Hz, 120Hz).

5.Audio Indicators - The front panel LED indicators monitor the power output level for the corresponding channel:

PEAK: The PEAK indicator lights whenever the channel is outputting signal at full strength. For the best signal-to-noise ratio, the right (PEAK) segment should light occasionally during peak levels; if it lights frequently, you may be overloading the amplifier and a distorted (“clipped”) signal is probably being output. If this occurs and backing off the Input Level control delivers too low an output level for your application.

-10:Lights whenever the output level reaches -10dB below the distortion or clipping

SIGNAL: These LED indicators continuously monitor the input level for the corresponding channel. The SIGNAL LED lights whenever signal is present.

10