Samsung NP900X3C manual Using the TPM Security Device Optional, Installing the TPM program, Method

Using the TPM Security Device (Optional)

Chapter 3. 71

Using the computer

5 When the system reboots, press the corresponding key(s) by following the onscreen instructions.

	When the computer restarts automatically and the Samsung
6 logo screen appears, press the F2 key repeatedly.
7	Select the Security > TPM Configuration > Change TPM
	Status item and set the item to Enable and Activate.
			Aptio Setup Utility
					Security
			TPM Configuration
		TPM Support		[Enabled]
		Change TPM Status		[	No Change	]
		Security Chip State			Disabled and Deactivated
					No Change
					Clear
					Enable and Activate
					Disable and Deactivate
8 Press the F10 key to save the changes.
	When the system reboots, press the corresponding key(s) by
9 following the onscreen instructions.

Installing the TPM program

You can install the TPM program as follows. Install the program according to the procedures below.

This program is only provided for models with Recovery and the TPM function.

Method 1

1 Run Recovery and click on System Software.

-If your computer does not boot up or if System Software does not display in the Recovery program, use Method 2 to install the TPM program.

2	Click on System Software Installation.
3	The SW Update program will be launched.
	Select TPM Host SW and click Install Now.

Press the F10 key to save the changes. The computer	If the system software media is supplied with the product,
	you can install the program by using the system software
10automatically restarts. Initialization of the TPM chip has been
	media (only when supplied.)
completed. Now, install the TPM program and register the
	4 After the installation, if you click OK, the computer restarts.
TPM program.