300
Appendix
Appendix
Optimum Picture Quality and Afterimage Burn-in Prevention
Optimum Picture Quality
To enjoy the optimum picture quality, go to Control Panel on your PC and adjust the resolution and
refresh rate as follows. The picture quality of TFT-LEDs may degrade if the optimum resolution is not
selected.
Resolution: 1920 X 1080
Vertical frequency (refresh rate): 56 ~ 75 Hz
Due to the nature of the manufacturing of this product, approximately 1 pixel per million (1ppm) may
be brighter or darker on the LED panel. This does not affect product performance.
The number of sub-pixels by LED panel type: PE40C, PE46C, PE55C: 6,220,800
Run "Auto Adjustment" to improve the picture quality. If noise is still found even after auto
adjustment, adjust Coarse or Fine.
Leaving the screen fixed on a stationary image for an extended period of time may cause afterimage
burn-in or defective pixels.
Activate power-saving mode or a dynamic screen saver if you will not be using the product for
an extended period of time.
Unlike CDT monitors, TFT-LED monitors (due to the nature of the panel) can be set to only one
resolution to obtain the optimum picture quality. Therefore, setting a resolution other than the
specified resolution may degrade the picture quality. To avoid this, it is recommended that you select
the optimum resolution specified for your monitor.