2) R-Gain 6) G-Offset
3) G-Gain 7) B-Offset
4) B-Gain
8)Gamma : An image compensation functio n that controls the settings according to the
video properties.
-Film : Picture Adjustment Film gamma.
-Video : The Gamma mode normal that matches a TV screen.
-Graphic : The Gamma mode that matches a PC screen.
Gamma
9)DynamicBlack™ : Adju sts the brightness and contrast of the screen by adjusting the
tightening thread in the optical system.
-Off : You can view the screen where the brightness is emphasized by opening the
tightening thread fully.
-Light : The tightening thread is opened less than in the Off state and more than in
the Middle and Deep states. The contrast is more emphasized than in the Off
state.
- Middle : The tightening thread is opened less than in the Light state and more than
in the Deep state. The brightness is more emphasized than in the Deep state.
-Deep : You can view the screen where the contrast is emphasized by closing the
tightening thread fully.
-Auto : You can view a more dynamic screen as the input screens are adjusted
automatically.
Dynamic
Black™
10)Save : Used to save custom picture settings.
Save
11)Reset : Restores the mode settings to the factory defaults.
Reset
Size You can select a screen size according to the type of scene.
▶ Refer to "Size Support Mode".
1) 16 : 9
2) Zoom1
3) Zoom2
4) Wide Fit
5) 4 : 3
Position Adjust the screen position if are not aligned.
▶ Refer to "Position Moving Support Mode".
Digital NR When a dotted line is displayed or the screen trembles, you can view picture in better
visual quality by enabling Noise Reduction.
▶ You can only enable the Digital NR in [Video], [S-Video] and [Component 1, 2]
modes.
Black Level Using the Black Level function, you can set the light level of the darkest portion of the
video signal so that you can clearly see dark areas on the screen.
1)0 IRE : Sets the light level of the darkest portion of the video signal to low. If the
setting does not match the input signal, the dark screen looks milky-white.
2)7.5 IRE : Sets the light level of the darkest portion of the video signal to high. If
the setting does not match the input signal, the dark screen is saturated and may
not display properly.
Color Pattern You can filter the color of the entire screen according to your taste.
1)Off : Shows the picture in the original color.
2)Monochrome : Shows the picture in black and white color by filtering out all color
signals.
3)Red : Shows the picture in red by filtering out the green and blue color signals.