When handling the lamp, avoid touching any part of it except for the handles. If you handle the lamp
incorrectly, it may affect the screen quality and shorten its lifetime.
LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED
OR DISPOSED OF ACCORDING TO LOCAL STATE OR FEDERAL LAWS.
For details see lamprecycle. org, eiae.org, or call 1-800-Samsung
Lamp Replacement Procedure
The lamp is very hot and operates
with a high voltage. Allow it to
cool down for at least 1 hour
after disconnecting the power
cord before changing the lamp.
The lamp is located at the left
rear of your projector. Place your
projector so that its left side is
visible and then remove the
screws on the lamp cover.
* Be careful your projector does
not fall.
Open the cover by holding down
(A) in the figure and pulling (B).
Remove the screws (A) in the
figure and then hold and open
(B).
Remove the screws as shown in
the figure.
As shown in the figure, lift up the
lamp handles holding them and
pull the lamp.
Assembling a new lamp is in the reverse order of the disassembly.
| Care and Maintenance | Contact SAMSUNG WORLDWIDE | Other |Authority |
If you have any questions or comments relating to Samsung products, please contact a SAMSUNG customer care center.
North America
U.S.A 1-800-SAMSUNG (726-7864) http://www.samsung.com/us
CANADA 1-800-SAMSUNG (726-7864) http://www.samsung.com/ca
MEXICO 01-800-SAMSUNG (726-7864) http://www.samsung.com/mx
Latin America