27
GB
With VCR Plus+, each channel is assigned a VCR Plus+ guide
number, which can be found in most TV program guides. If your
VCR comes with VCR Plus+, you can use this system when
recording. Before using VCR Plus+, set the channel and VCR Plus+
numbers to match.
* VCR Plus+ is trademark of Gemstar Development Corporation.
Be sure to select the correct signal source (Antenna/Cable TV
depending on your hook-up) before performing Guide Channel
Setup.
1Press MENU for the Main Menu. Press and to select
“INSTALLATION”. Press and to select “MANUAL SET UP”.
2Press to select “GUIDE CH SET UP”.
3VCR Plus+ Guide channel numbers appear on the top row.
Receiving channels are on the bottom.
Press or to select a VCR Plus+ Guide channel number.
4Press or for the correct receiving channel number.
For example : If receiving channel 23 corresponds to the
VCR Plus+ Guide channel 45, press and until 45 appears in
the top row of numbers with the downward pointing arrow directly
below.
Press the and until 23 appears on the bottom row.
The channel number that changes is always the receiving channel
rather than the VCR Plus+ Guide channel.
5Press or to select the next VCR Plus+ Guide channel
number. Enter all the receiving channel numbers and press MENU
to finish.
VCR Plus+ Set up (AMERICA Only)
** INSTALLATION **
COUNTRY
ANT./CATV:ANTENNA
AUTO SET UP
¨
MANUAL SET UP
¹
¨
END:(MENU)
** MANUAL SET UP **
¨
GUIDE CH SET UP
CH ADD/DELETE
RF OUT M/G/I/K :M
RF OUT CH 116-125:60
¹
¨
END:(MENU)
** GUIDE CH SET UP **
40 41 42 43 44 45
40 41 42 43 44 45
ENTER ACTUAL
RECEIVING CHANNEL
¹
¨
END:(MENU)
** GUIDE CH SET UP **
40 41 42 43 44 45
40 41 42 43 44 23
ENTER ACTUAL
RECEIVING CHANNEL
¹
¨
END:(MENU)
00575A)SV-7000W-GB-2 11/19/99 3:45 PM Page 27