ENJOYING OTHER SOURCES
1. Press [FUNCTION] to select “AUX”.
2.Follow the instructions supplied with TV or other compatible/ video component.
SLEEP TIMER OPERATION
The sleep timer automatically switches off the power after a preset time has elapsed. The volume will gradually be reduced
Press [SLEEP] repeatedly while holding [SHIFT] down to select the desired sleep time. “SLEEP” appears, and the selected time blinks on the display.
After several seconds, the original display returns and the brightness of the display reduces. “SLEEP” blinks on the display.
To check the remaining sleep time
Press [SLEEP] once while holding [SHIFT] down. The remaining time is displayed.
After several seconds, the original display returns.
To release the sleep timer while in operation
Press [SLEEP] repeatedly while holding [SHIFT] down until “SLEEP” disappears.
The timer is also released if the power is switched off.
MAINTENANCE
WARNING:
FOR YOUR PERSONAL SAFETY, BE SURE TO DISCONNECT THE AC POWER CORD BEFORE PROCEEDING WITH ANY MAINTENANCE OR CLEANING.
Cleaning the cabinet
Use a clean soft cloth moistened with plain lukewarm water and wrung dry. Never use benzol, benzene or other strong chemical cleaners since these could damage the finish of your unit. It is important that no liquid reaches the inside of the unit.
Cleaning the DVD player lens
The lens should never be touched. If dust is on the lens, blow it off using a camera lens blower. (Please consult your dealer.)
TROUBLESHOOTING GUIDE
If you have followed the instructions and are having difficulty operating the unit, locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to locate and remedy the problem.
SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION | |
|
|
|
|
No power. | No power plug connection at the AC wall outlet. | Insert the power plug into the AC wall outlet. | |
|
|
|
|
|
| The system cable is not connected. | Connect the system cable. (See page E8.) |
|
|
|
|
The power is on, but the player does not | No disc is loaded. | Load a disc. | |
work. |
|
| |
|
|
| |
No picture. | An unplayable disc is loaded. | Load a playable disc. (Check the disc logo, type, | |
|
|
| color system and region number.) (See page E20.) |
|
|
|
|
|
| The TV is not set to receive signal from the unit. | Select the correct input function on the TV. |
|
|
|
|
|
| The video cable is not connected. | Connect the video cable into the jack. |
|
|
|
|
|
| “PROGRESSIVE” mode is set. | Select “INTERLACE” mode. (See page E21.) |
|
|
|
|
