Sanyo VCC-5984 14

SETTINGS

Normally the switch 8 (WB) is set to the down (ATW: auto white

balance) position and the white balance is a djusted automatically. If a

manual white balance adjustment is necessary, follow the steps below.

Set the switch 8 (WB) to the up (M: manual) position, then adjust the

colour.

•Turn RED (VR302) to set the red ratio and/or BLUE (VR303) to set

the blue ratio.

1Connect the VBS signal output for the other camera to the VBS IN

connector at the rear of this camera.

2If the signals are not synchronized, change the sub-carrie r

(SC-PHASE) switches as follows.

Setting 9-pin 10-pin

Default OFF (down) OFF

Set to 90° countercloc kwise OFF ON (up)

Set to 180° countercloc kwise ON OFF

Set to 270° countercloc kwise ON ON

Note:

•The sub-carrier switches let you make broad adjustme nts to the

sub-carrier phase. If finer adjustments ar e required, contact the

place of purchase.

•The type and length of the cable which is connected to the VBS

connector may cause the horizontal synchronization being out of

phase. If this happens, adjust VR304 (H: hor izontal sync).

VR303

VR302

L53H4/US2 (VCC-5984) GB 2003, 1, 7

14 English