3.3INSTALLATION

1.How to Install the Fixing Bracket

Useスペtheーサspacersーを必as要muchなぶasんyou重ねneedて使用する。

Figure 3-5 Installing the Fixing Bracket

∗Use the spacers depending on the fitting panel thickness referring to the next table. If not, the body may be deformed, and therefore it may be hard to open the paper cover or printing quality may be deteriorated. (If the fitting panel thickness exceeds 2.2 mm, it may be hard to tighten the screws.)

Panel thickness

Spacer

Panel thickness

Spacer thickness

thickness

 

 

 

1.0 mm

None

1.7 to 1.8 mm

0.5 mm and 0.2 mm

1.2 mm

0.2 mm

2.0 mm

1.0 mm

1.5 to 1.6 mm

0.5 mm

2.2 mm

1.0 mm and 0.2 mm

∗The screw torque is 49 cN m (5 kgf cm). [Note] Do not touch the end of the DC plug.

2.Setting Paper

(1)Press the paper cover open button, and open the paper cover.

Handle the paper cutter carefully not to cut your hand.

(2)Set a paper roll as shown in the figure.

(3)Close the paper cover by pressing both ends of the cover so the tip end of the paper will be emerged from the printer.

3-4