1.2.2Handling Precautions
Incorrect handling may reduce the efficiency of the printer and cause damage. Handle the printer with the following precautions.
Also, include any necessary precautions so that users handle the printer with care.
zTo prevent the heat elements, ICs, etc. from static electricity, discharge all static electricity before handling the printer.
Pay special attention to the thermal head control terminals when handling.
zDo not apply stress to the thermal head control terminals: Doing so may damage the connectors.
zIf any paper other than that specified is used, high print quality and long life of the thermal head cannot be guaranteed.
zUsing anything other than the specified paper may cause the following: Poor printing quality
Abrasion of the thermal head
The thermal surface of the paper and the thermal head may stick together Excessive noise
Fading print
Corroded thermal head
zAlways print or feed with the specified paper inserted to protect the platen and thermal head.
zDo not hit or scratch the surface of the thermal head with any sharp or hard objects as it may damage the heat element.
zWhen the printer is not in use, place the thermal head in up position.
The head down (platen “close” state) and head up (platen “open” state) positions can be set with head up/down lever.
If the thermal head is remained in contact with the platen, the platen may become deformed.
zNever connect or disconnect cables with the power on. Always power off the printer first.
zWhen printing a black or checkered pattern at a high print rate in a low temperature or high humidity environment, the vapor from the paper during printing may cause condensation to form on the printer or may soil the paper.
If water condenses on the printer, keep the thermal head away from water drops as it may corrode the thermal head, and turn Vp off until it dries.
zThe printer is not
zNever use the printer in a dusty place, as it may damage the thermal head and cause paper feed trouble.