FINISHER
3-11
3
■
■■
■Checking the staple unit
If the message "CHECK THE STAPLER UNIT" or "CHECK STAPLER POSITION OR STAPLER JAM" appears,
follow the procedure below.
1Open the finisher compiler.
Release the latch to
open the finisher
compiler.
2Remove the misfed paper from the stapler
compiler.
Be careful not to tear the
misfed paper during
removal.
3Close the finisher compiler.
4Open the finisher front cover.
5Turn the staple unit to face up.
6Pull the release lever for the staple box
and remove the box.
7Raise the lever at the end of the staple box.
Remove the top staple if
it is bent. If bent staples
remain, a staple jam will
occur again.
8Return the lever to its original position.
9Reinstall the staple box.
Push the staple box in
until it clicks into place.
10
While pushing the staple unit release lever to
the left, rotate the staple unit to face down.
When reinstalling the
staple box, push it in
until it clicks into place.
11
Close the front cover.
NOTE
Make a test print or copy in the staple sort mode to
ensure that stapling is performed properly.